Victron BlueSmart IP65 smart battery charger 12V/15A + DC connector

Victron BlueSmart IP65 charger Water and dust resistant charger with built-in Bluetooth technology, allowing you to display information from your charger to your smartphone, tablet or computer. Optimal for batteries with a capacity of 80-180 Ah. Built-in Bluetooth technology for setting, displaying voltage and current Resistance to dust, water and chemicals Intelligent seven-stage charging algorithm Recovery of a completely discharged "dead" battery Automatic power supply function Resistant to low temperatures down to -30 °C Several other functions to increase battery life Low power mode for charging small batteries Special mode for charging Li-ion batteries 5-year Bluetooth warranty You can set up, view the status and configure the Blue Smart IP65 charger via your smartphone. You can even control the charger's functions using the VictronConnect app. The default voltage and current value is displayed on the screen. You can download the VictronConnect app for free on Google Play or the App Store. This app is not yet available for mobile phones with the Windows operating system. Regeneration A lead acid battery that has already been undercharged or left discharged for several days or weeks will deteriorate due to sulfation. If detected early, sulfation can sometimes be partially reversed by charging at a low current until the battery reaches a higher voltage. Recovery function for completely discharged batteries Most reverse polarity protected chargers will not recognize batteries that have been discharged to zero or near zero voltage and will therefore not start charging them. However, the Blue Power Charger will attempt to recharge even a completely discharged battery at a low current, restoring normal charging as soon as sufficient voltage is present at the battery terminals. Ultra-high efficiency “green” battery charger With an efficiency of up to 94%, these chargers produce up to 4x less heat than the industry standard. When the battery is fully charged, power consumption is reduced to 0.5W, which is 5x to 10x better than the standard. Long life, safety and quiet operation Low thermal load on electronic components. Protection against dust, water and chemicals. Overheating protection: the output current will decrease with increasing temperature up to 60°C, but the charger will not fail. The chargers are completely silent: they do not contain an active heat sink (fan) or other moving parts. Storage mode: less corrosion of the positive electrodes Even the lower trickle charge voltage that follows the absorption phase can cause grid corrosion. It is therefore essential to continue to reduce the charging voltage if the battery remains connected to the charger for more than 48 hours. Temperature-compensated charging The optimal charging voltage for a lead-acid battery varies inversely to its temperature. The Blue Power IP65 Charger measures the ambient temperature during the test phase and compensates for it during charging. The temperature is measured again when the charger is in low current mode during maintenance or storage. Therefore, there is no need for special settings for cold or hot environments. Charging mode for Li-ion batteries The Blue Power Charger uses a special charging algorithm with automatic reset of the undervoltage protection of Li-ion batteries (for Li-ion (LiFePO4) batteries). Normal charging voltage mode 14.4 V - suitable for gel and AGM batteries. High charging voltage mode 14.7 V - suitable for open flooded batteries. BASIC SPECIFICATIONS Efficiency: 94% Input voltage (AC): 180-265 V (45-65 Hz) Charging current: 15 A Absorption charging voltage: 14.4 V Float charging voltage: 13.8 V Storage mode voltage: 13.2 V Power consumption without load: 0.5 W Protections: output polarity reversal, output short circuit, overheating Battery output: black and red cable 1.5 m long 230 V AC charger input: 1.5 m cable with classic plug Degree of protection: IP65 Plug type: CEE 7/7 (Schuko) Weight: 0.9 kg Dimensions: 190 x 105 x 60 mm The package includes power cables with M8 eyelets and crocodile clips. Cables with fuse and other accessories can be found in related products. VictronConnect application for Android mobile devices VictronConnect application for iOS mobile devices VictronConnect application for Mac devices The application is also available for download on the Victron Energy manufacturer's website (Mac/Windows/Linux/iOS/Android): https://www.victronenergy.com/support-and-downloads/software#victronconnect-app